Систематические BSODы (ошибка 131)

The processor (CPU) may be defective and needs to be replaced. Before taking this step, check if any of these more common issues are occurring that will cause the processor to fail:
Confirm both the CPU and system fans are working properly
The CPU is properly seated in it's socket and the clamps are in place
There is sufficient thermal compound between the CPU and the CPU heatsink
The CPU is not being overclocked (via BIOS motherboard settings

If you do replace the CPU with a different model (higher speed or more cores) confirm the power (watts) is the same or lower than the current CPU, or ensure you add additional cooling for the hotter part.

Check Memory


You may have a defective memory. This is even more likely if it only occurs when the system is cold or hot, but not all the time. Use a memory tester to confirm if it is defective or if you have spare memory, try replacement.

Windows 7 and Vista include a Memory Test program when booting from the Windows Installation DVD. Step-by-step instructions with screen shots are available at Using System Restore on 7/Vista/2008 as part of System Recovery.

Several software products that also provide memory and video diagnostics includes Fix-It Utilities Professional and SystemSuite Professional. Other diagnostic products include Eurosoft's PC Check and Iolo's System Mechanic.

Additional Memory Solutions:
Confirm all the memory is of the same type and speed. Many motherboards only work correctly when the memory is installed with matched sets and matched speeds.
If you added or changed your memory just before this problem occurred, try reverting to the prior memory configuration to confirm it's the source of the problem.
Check that the memory is fully seated in the sockets. Memory sockets often have side latches that need to be upright to indicate the memory is correctly locked in place.
Confirm the memory resides in the correct slots on the motherboard. You'll need to refer to the motherboard manual to confirm this. There is little consistency, even within a single vendor. Some systems require that memory is installed as matched pairs, but not always adjacent to each other!
It's also possible the memory problem is on the video card, as they often contain additional memory. The video card should be tested and/or try a different video card to see if the problem goes away.

Attempts To Start Sound Blaster Audigy Value Causes Bluescreen
During the upgrading process from Window Vista Ultimate to Windows 7 build 7000, any attempts to start the sound card results in a blue screen (stop 0x00000131).

After removing the sound card, the upgrade process went smoothly.

After Windows 7 boots up successfully, I shut it down and installed the sound card again.

Windows 7 detected the card and installed the drivers, but blue screens again when trying to start it.

When I look the device up in device manager, I see that the drivers are dated 2007 from Creative, which can't be right. I presume that Windows 7 is attempting to use the old Vista drivers that was installed prior to the upgrade.

Does Windows 7 have the latest drivers for Audigy? Are Vista's drivers suppose to work in Windows 7?

How do I remove the old drivers and let Windows update install the latest drivers?